Organizational ribbon
Updated 28.11.2021
TSTS ry's ribbon guidelines
All current and former board members of TSTS ry have the permanent right to use the organization ribbon. The TSTS board may also grant the right to use it to other distinguished members of TSTS ry, either temporarily or permanently.
The ribbon is worn on occasions appropriate to the value of the ribbon, where the dress code mentions insignia or organizational ribbons.
The ribbon falls from the right shoulder to the left waist. In formal wear, the ribbon is worn under the jacket and waistcoat, but always over the tie. The ribbon should not touch bare skin. Therefore, the ribbon can also be worn as a rosette on the left breast of the suit.
(see instructions below).
You can also wear other ribbons with the TSTS ribbon. At TSTS events, the TSTS ribbon is worn on top.
Rosette:
Cut approx. 50 cm of ribbon.
Fold the ribbon exactly as shown in the picture below. Follow the measurements.
NOTE!
Only one side of the ribbon is shiny. Fold it so that the shiny side is visible!
Leave the excess ribbon hanging, and sew a few stitches through all layers in the middle of the rosette.
Make sure that all layers are attached with stitches and that the dimensions do not change.
Leave the thread untied until ready to sew.
Fold the remaining ribbon from the wrong side into the center of the rosette as shown. Wrap the center ribbon around the rosette once.
Cut off the excess ribbon. Sew the end of the ribbon closed with a few stitches so that the stitches are not visible on the front.
Conclude.
It is important that your stitches are not visible on the representative, or shiny, side!
If you need help, just ask the government!
Preparation instructions
Over the shoulder:
Test the appropriate length of the ribbon. The ribbon should comfortably extend from the right shoulder to the left waist. The ends are hidden together, for example with a safety pin.
